DC500 Accessory Installation

Push Button & Keypad

Key Push Button

 key button key button

Wireless Keypad

DC500 gate opener - wiring

  • Receiver CM: direct to gate opener board terminal COM
  • Receiver NO: direct to gate opener board terminal PB1
  • Receiver VDD: electric opener to +12v on board
  • Receiver GND: electric opener to (photocell) COM
DO NOT REMOVE BLACK LOOP WIRE

Please contact the office if you require help with resetting pin codes or deleting.

Tuning Standard Remotes

Step 1. Press "LEARN CODE" button, the LED2 will flash, then press top left "REMOTE BUTTON", the LED2 stops flashing, now the new code is stored. Press the top left "REMOTE BUTTON", you can operate the sliding gate for full open, with each press the gate will enter into "open, stop, close cycle"

Step 2. Press "LEARN CODE" button once again, the LED1 will flash, then press the top right "REMOTE BUTTON", the LED1 stops flashing, now the new code is stored. Press the top right "REMOTE BUTTON", you can operate sliding gate for pedestrian open.

Tuning Long Range Remotes

DC500 gate opener

  • Receiver COM: direct to gate opener board terminal COM
  • Receiver NO: direct to gate opener board terminal PB1
  • Receiver +12v: electric opener to +12v on board or solar opener to regulator (5)
  • Receiver – GND: electric opener to (photocell) COM on board or solar opener to regulator (6) DO NOT REMOVE BLACK LOOP WIRE

TO PROGRAM REMOTES TO THE RECEIVE

  • Step 1: press and hold remote button that is to trigger the opener. It is important that this button is continuously held from step 1 through to step 3.
  • Step 2: place the jumper over the two LEARN pins on the PC Board for 2 seconds.
  • Step 3: remove the jumper from the two pins.
  • Step 4: release the button on the remote.
    That particular button on the remote is now programmed to the receiver.

TO ERASE ALL REMOTES

  • Step1: Place the jumper across the two ERASE pins
  • Step2: The LED will flash 4 times to warn you that the remotes will be erased after which the LED will stay solid red
  • Step 3: When the LED remains on solid, all the remotes have been erased
    Remove the jumper

    Eyebeams - Wired

    BMG Imports Brendale

    Find Us

    • BMG Imports
    • 24/302 South Pine Road
      Brendale, QLD, 4500

    • Tel: 07 3205 3002
    • Hours: Monday - Friday 8.30am - 5pm
    Copyright © 2017 BMG Imports. All Rights Reserved.
    Joomla! is Free Software released under the GNU General Public License.