Servicing Your Gate and Motor

Your gate and gate motor are both very important pieces of equipment.  This equipment is like a vehicle, which requires preventative maintenance especially on the coast where corrosion is a big factor.

The following MUST be done at regular intervals: (3-4 months)

  1. Basic battery load test: turn the mains off, check the battery voltage with a multi-meter while the motor is running. The voltage must NOT go below 11 volts DC. If it goes below 11 volts, replace the battery.  
  2. Charge Voltage: switch the mains on. Remove battery leads from the battery and measure the charge voltage on the battery leads to ensure that the charge voltage is between 13.4 to 13.8v. 
  3. Check for insects, snakes and geckos in and around the PCBoard. Although the PCBoard is covered by a neat fitting plastic housing, it is still possible for ants to make their way onto the board.
  4. The gate must be lifted and the wheels that run on the rail must be checked to see that they spin freely and that the bearings haven’t collapsed, this is very important to ensure the life span of your gate motor.
  5. The gate guide wheels must be checked to see that they spin freely and ensure that they are not worn and the lock nuts are tight.
  6. Over time the gate wheels tend to bed themselves in, as a result the gate’s gear rack now rides directly on the motor’s main drive pinion gear. There should ordinarily be a 2 mm gap between the gear rack and the pinion gear. Another indication of this “binding” situation is when the motor vibrates excessively while the gate is running. This fault causes unnecessary wear and tear and will reduce the life of the operator and it must be rectified without delay. The rack can also become too loose and the gap becomes too big, which causes the pinion gear to skip the teeth on the gear rack causing a malfunction.
  7. If safety beams are fitted, check for any insects and ensure that there are no loose or broken wires inside the beams.
  8. Remove any plants, trees or branches that may cause an obstruction to the wheels and a blockage to the beams.
  9. Check that the operator’s foundation plate bolts are still secure.
  10. Check that the ends stops are still secure.
BMG Imports Brendale

Christmas break  
Closing - 12pm 21.12.2018 
Re opening - 8.30am 07.01.2019

BMG Imports

  • 24/302 South Pine Road
    Brendale, QLD, 4500

    07 3205 3002

    Business Hours:

    Mon-Fri: 8.30am - 5pm

    Sat-Sun: Closed

Copyright © 2018 BMG Imports. All Rights Reserved.
Designed and developed by DigiDevs Logo