Please use telecom cable for wiring and it’s recommended to silicone between the back plate and the post to stop water and insects entering the rear of the keypad.

4 cables from the keypad to the gate opener:

Swing gate opener

Keypad COM: direct to gate opener control board terminal (P.SW) COM
Keypad NO: direct to gate opener control board (P.SW) side 1 if single or side 2 if double
Keypad +12v: direct to gate opener control board or solar regulator (5)
Keypad –GND: direct to gate opener control board or solar regulator (6)

Electric slide 240volt

Keypad COM: direct to gate opener control board terminal COM (#2)
Keypad NO: direct to gate opener control board terminal ONE (#4)
Keypad +12v: direct to gate opener control board +15v (#1)
Keypad –GND: direct to gate opener control board COM (#2)

DC/Solar slide

Keypad COM: direct to gate opener control board terminal COM
Keypad NO: direct to gate opener control board terminal PB1
Keypad +12v: direct to gate opener control board or solar regulator (5)
Keypad –GND: direct to gate opener control board or solar regulator (6) DO NOT REMOVE BLACK LOOP WIRE

SPRINT/CONDO slide

Keypad COM: direct to gate opener control board terminal GND
Keypad NO: direct to gate opener control board terminal TRIG
Keypad +12v: direct to gate opener control board terminal 12/24V
Keypad – GND: direct to gate opener control board terminal GND

KEYPAD SETTINGS

Double gate setup (allows 2 gates to open)

Press # (red light comes on)
Press 1234 6 000 1

Removing backlight

Turn light off Press # 1234 6 2800
Turn light on Press # 1234 6 2801
Light comes on when entering pin number Press # 1234 6 2802

If you have lost your instructions, please contact BMG Imports for adding or deleting pin codes

Terms & Conditions | Login