The Transmitter is fitted with a RED LED which indicates when the power is on.
The receiver is fitted with a RED LED which indicates when the beams are aligned.
2. Manufacturers Comments:
It is recommended that beams be sealed with silicone rubber once they are closed.
Beams can be affected by florescent lights. It is not recommended that the beams be placed in direct view of florescent pillar lights.
The range of the beams can be affected by environmental conditions. Rain, mist etc can reduce the range of the beams.
Ensure that the power is disconnected before wiring the beams.
3. Fitting Beams to the Gate Post:
Beams should be placed around 700mm high above the ground level. The transmitter and receiver must, however, be aligned along a visual (and level) axis.
If aligning the beams over a distance greater than 20m it is necessary that the covers be replaced in order to achieve alignment.
Remove the PC Boards from both transmitter and receiver units.
Place the housing backing against the pillar at the prescribed spot and scribe through the screw holes.
Drill at the scribed marks using a 5mm masonry drill.
Attach the housing backing to the wall using the supplied fasteners and 'O' ring. Ensure that the 'O' ring is fitted to the top fastener.
Replace the PC Boards and follow wiring instructions as per gate motor manual or BMGs wiring guides below.
4. Technical Specifications:
Power Supply: 12V-24V DC/AC
Max. Distance: 40m
Output Contact Rating: 5A at 220V AC
Click on the motor you have below to see the wiring diagram:
