LW550 Accessory Installation (old model)

Keypad
Please use telecom cable for wiring and it’s recommended to silicone between the back plate and the post to stop water and insects entering the rear of the keypad.
4 cables from the keypad to the gate opener:

LW550 gate opener

  • Keypad COM: direct to gate opener control board terminal COM (#5)
  • Keypad NO: direct to gate opener control board terminal ONE (#9)
  • Keypad +12v: direct to gate opener control board (#1)
  • Keypad –GND: direct to gate opener control board COM (#2)

Please contact the office if you require help with resetting pin codes or deleting.

keypad
Wireless Keypad

LW550 gate opener - wiring

  • Receiver CM: direct to gate opener board terminal COM (#5)
  • Receiver NO: direct to gate opener board terminal ONE (#9)
  • Receiver VDD: direct to gate opener board (#1)
  • Receiver GND: direct to gate opener board (#2)

Please contact the office if you require help with resetting pin codes or deleting.

Tuning Standard Remotes
Press the little button as shown on the board below quickly (if held down too long you will wipe all remotes) then press any button on the remote once and then once again. You will hear a beep and your remote is now tuned in. Repeat again if the first tune didn't work.
Tuning Long Range Remotes

LW550 gate opener

  • Receiver COM: direct to gate opener board terminal COM (#5)
  • Receiver NO: direct to gate opener board terminal ONE (#9)
  • Receiver +12v: direct to gate opener board (#1)
  • Receiver GND: direct to gate opener board (#2)

TO PROGRAM REMOTES TO THE RECEIVE

  • Step 1: press and hold remote button that is to trigger the opener. It is important that this button is continuously held from step 1 through to step 3.
  • Step 2: place the jumper over the two LEARN pins on the PC Board for 2 seconds.
  • Step 3: remove the jumper from the two pins.
  • Step 4: release the button on the remote.
    That particular button on the remote is now programmed to the receiver.

TO ERASE ALL REMOTES

  • Step1: Place the jumper across the two ERASE pins
  • Step2: The LED will flash 4 times to warn you that the remotes will be erased after which the LED will stay solid red
  • Step 3: When the LED remains on solid, all the remotes have been erased
    Remove the jumper
    BMG Imports Brendale

    Christmas break  
    Closing - 12pm 21.12.2018 
    Re opening - 8.30am 07.01.2019

    BMG Imports

    • 24/302 South Pine Road
      Brendale, QLD, 4500

      07 3205 3002

      Business Hours:

      Mon-Fri: 8.30am - 5pm

      Sat-Sun: Closed

    Copyright © 2018 BMG Imports. All Rights Reserved.
    Designed and developed by DigiDevs Logo